I have designed the Lancer in memory of an old friend and huge enthusiast of Fun Flys Lance Bell. Lance not only helped me learn to fly but introduced me to the world of Fun Flys and competitions. It was all about competitive fun, a plane that was quick and fun to build and the endless tweaks that can be made to save a gram of weight or make those loops and rolls that little tighter and snappier!

The kit has been designed for the most of it to all interlink and so doesn’t require a plan to build (Schematic supplied)over and only requires basic shaping (Leading edges and fuselage profiling) and the hardware pack is a very comprehensive pack requiring very little to get you flying.

Specification & Equipment required

• Wingspan: 1200mm / 47.2”
• Length: 995mm / 39.1”
• Weight: 1350gr Approx without battery
• Radio: 5 Channel
• Motor/Battery: 900Kv (4s) or 1200Kv (3s), Batterys I have ran a range of 3s & 4s 2500 – 5000mah
• ESC: 60A (4s) or 80A (3s) (Have ran both on 60A with no issues)
• Servos Required: 4 Servos MacGregor MG1703DS Recommended
• The most important thing though is HAVE FUN

Wood stock & Hardware Supplied

• M2 Clevises x 10
• Threaded rod 8” x 3
• Closed Loop kit (120cm Wire, Crimps x 4, Threaded adaptor x 2)
• 8SWG Saddle Clamps x 4
• Magnets for hatch x 4
• 600mm Wing Seat Tape
• 80mm sticky back Velcro for esc and RX
• M3 T nuts for wing fences x 4
• Control Horns small x 5
• Pinned Hinges x 16 (Assemble two halves together with a supplied pin pushed all the way through)
• 4 x M3 Nylon Bolts for the Wing fences
• Screws for the undercarriage (3x7mm approx. x 8) & Control horns (2x13mm approx. x 8)
• 8SWG Collets & 4 Grommets (V.Small & Black!)
• 6SWG Elevator Joiner
• Undercarriage Legs front and back
• 2 x Lite foam wheels
• 120cm Binding wire for the undercarriage joints
• All Woodstock and laser cut parts required to finish the build

Required to complete build

• T Nuts to suit your chosen motor
• FLAT Building Board/Surface, Straight edge and Square
• Wood plane for shaping the Leading edge
• Sandpaper or Sanding tools to profile the fuselage and final sand all components
• Pins
• Z Bend pliers for the servo control rods (You can do a 90degree bend instead but you will need to source a suitable retainer)
• Flux and solder for the undercarriage (Either use mini gas torch (preferred) or heavy duty soldering iron)
• Wing Bands (Recommend 7”)
• Covering of choice (Our prototype model was covered using Hendersons Chequer and bright orange film along with some transparent red Oracover)
• Medium Cyano
• Ultra Thin Cyano
• Thick Slow Set Cyano
• Activator (Optional)
• PVA glue if you prefer over Cyano
• 5 minute Epoxy (Can use longer setting if that’s what you have)